STABILOCK 4032 and TETRA MS Test

Details of supported measurements are provided in the following list. Generally speaking, there are two test modes: One is for measurements on a traffic channel (requires the MS to register with the 4032 and to set up a call), and the other is a measure-only mode (MS in test mode, or TX measurements on a base station).

• TX power

• TX frequency error

• Residual carrier power

• RMS/peak vector error magnitude

• Timing error (frame alignment)

• Audio analysis (frequency and voltage) on signal from AF connector while on traffic channel

• Power versus time (burst analysis)

• Constellation display

• Modulation spectrum display (normal, averaged, peak-hold)